User's Manual

Table Of Contents

Setting Up: Advanced

Linksys EA-Series

Click the setting for DMZ to turn it on.

Select Enabled.

In the Source IP Address section, select Any IP Address to allow access to

your DMZ device from the entire Internet, or select the alternate button

and enter a range of allowed source addresses.

In the Destination IP Address section, enter the last three digits of the IP

address of the device that will be in the DMZ. The rest of the IP address is

already completed.

- OR -

If you want to specify the 12-digit MAC address of the device instead of

setting up a DHCP address reservation, you can replace Step 6 with the

following steps:

In the Destination IP Address section, select MAC Address, then click

View DHCP Client Table. The DHCP Client Table screen opens.

Click Select next to the device that you want to place in the DMZ,

then click Close. The corresponding MAC address is copied into the

MAC Address field.

Click OK.