Owner's Manual

Instant RAID

The Instant RAID has three LEDs for each disk, and six status LEDs.

RAID LEDs

Activity This LED flashes green when the disk is being

accessed.

Failure This LED is normally off. It will illuminate red if

the disk is not installed, or has failed.

Rebuilding This LED is normally off. When a new disk is

inserted, this LED will illuminate orange, indicat-

ing that data is being copied from the other disk. It

will continue to illuminate until the mirroring is

complete, then it will turn off.

Status LEDs

Ready This LED will illuminate when the Instant RAID

is on, will blink during startup or shutdown, and

will be off after the shutdown is complete.

Error This LED is normally off. It will illuminate amber

during self-test, and turn off after the test is com-

plete. If it remains on, a hardware error is indicat-

ed.

During a software upgrade, both the Ready and

Error LEDs will blink.

Linksys EtherFast

Series

Printer Port The Printer Port is where you can connect the

Instant RAID to your printer using a printer cable.

Uplink Button When connecting directly to a computer via

Ethernet, this button should be depressed.

For normal operation (connecting to a hub or

switch), this button should be UP.

LAN Port Use this port to connect the Instant RAID to your

10BaseT or 100BaseTX hub or switch.

100BaseTX LED indicator This LED will glow amber if the LAN Port is

using 100BaseTX.

10BaseT LED indicator This LED will glow green if the LAN Port is using

10BaseT.

Front Panel