Owner's Manual

Protocol Setup For Windows

95 and 98

Each PC that will be connecting to the Internet must

have TCP/IP installed and it must be configured to the

following settings.

The instructions below apply to Windows 95 and 98.

Suggested setup instructions for Windows NT 4.0 are

listed in the Appendix of this guide. The setup, config-

uration, and troubleshooting of TCP/IP on any other

operating system is strictly up to the user. Refer to the

documentation and instructions accompanied by the

operating system.

1. Click on the Start button, select Settings, Control

Panel. The Control Panel window will be displayed.

2. Double-click on the Network icon.

3. Check the list of installed network components. If

TCP/IP is not installed for your network adapter,

install it now by clicking the Add button. If TCP/IP is

already installed, go to step 7.

4. In the Network Component Type dialog box, select

Protocol and click Add.

5. In the Select Network Protocol dialog box, select

Microsoft.

6. In the Network Protocols area of the same dialog

box, select TCP/IP, then click OK. You may need to

provide your Windows 95 or 98 CD to complete the

installation.

router.qxd 12/16/99 12:22 PM Page 18