User Guide
Table Of Contents
- Chapter 1 - LAPN300
- Chapter 2 – Access Point Setup
- Administration
- User Level
- New Password
- Confirm New Password
- Automatically
- LAN
- Wireless
- Select SSID
- Primary Server
- Primary Server Port
- Primary Shared Secret
- Backup Server
- Backup Server Port
- Backup Shared Secret
- Captive Portal
- MAC Address
- IP Address
- User Name
- SSID Name
- Online Time
- Away Timeout
- Session Timeout
- Cluster
- System Status
- Maintenance
- Appendix A – Troubleshooting
- Appendix B – About Wireless LANs
- Appendix C – PC and Server Configuration
100
•
There must be a ‘‘client login’’ for the wireless access point itself.
The wireless access point will use its default name as its client login name. (However, your RADIUS
server may ignore this and use the IP address instead.)
The
Shared Key
, set on the
Security
Screen of the access point, must match the
Shared Secret
value
on the RADIUS server.
Encryption settings must be correct.
802.1x Server Setup (Windows 2000 Server)
This section describes using
Microsoft Internet Authentication Server
as the RADIUS server, since it
is the most common RADIUS server available that supports the EAP-TLS authentication method.
The following services on the Windows 2000 Domain Controller (PDC) are also required.
•
dhcpd
•
dns
•
rras
•
webserver (IIS)
•
RADIUS Server (Internet Authentication Service)
•
Certificate Authority
Windows 2000 Domain Controller Setup
Run
dcpromo.exe
from the command prompt.
Follow all of the default prompts, ensure that DNS is installed and enabled during installation.
Services Installation
1.
Select the Control Panel > Add/Remove Programs.
2.
Click Add/Remove Windows Components from the left side.