User Guide
Table Of Contents
- Chapter 1 - LAPN300
- Chapter 2 – Access Point Setup
- Administration
- User Level
- New Password
- Confirm New Password
- Automatically
- LAN
- Wireless
- Select SSID
- Primary Server
- Primary Server Port
- Primary Shared Secret
- Backup Server
- Backup Server Port
- Backup Shared Secret
- Captive Portal
- MAC Address
- IP Address
- User Name
- SSID Name
- Online Time
- Away Timeout
- Session Timeout
- Cluster
- System Status
- Maintenance
- Appendix A – Troubleshooting
- Appendix B – About Wireless LANs
- Appendix C – PC and Server Configuration
16
Time Screen
Time
Current Time
Display current date and time of the system.
Manually
Set date and time manually.
Automatically
When enabled (default setting) the access point will get the current time
from a public time server.
Time Zone Choose the time zone for your location from the drop-down list. If your
location observes daylight saving time, enable “Automatically adjust clock
for daylight saving changes.”
Start Time
Specify the start time of daylight saving.
End Time
Specify the end time of daylight saving.
Offset
Select the adjusted time of daylight saving.
NTP
NTP Server 1 Enter the primary NTP server. It can be an IPv4 address or a domain name.
Valid characters include alphanumeric characters, "_", "-" and ".". Maximum
length is 64 characters.
NTP Server 2 Enter the secondary NTP server. It can be an IPv4 address or a domain
name.
Valid characters include alphanumeric characters, "_", "-" and ".". Maximum
length is 64 characters.