User Guide
Table Of Contents
- Chapter 1 - LAPN300
- Chapter 2 – Access Point Setup
- Administration
- User Level
- New Password
- Confirm New Password
- Automatically
- LAN
- Wireless
- Select SSID
- Primary Server
- Primary Server Port
- Primary Shared Secret
- Backup Server
- Backup Server Port
- Backup Shared Secret
- Captive Portal
- MAC Address
- IP Address
- User Name
- SSID Name
- Online Time
- Away Timeout
- Session Timeout
- Cluster
- System Status
- Maintenance
- Appendix A – Troubleshooting
- Appendix B – About Wireless LANs
- Appendix C – PC and Server Configuration
20
HTTPS
HTTPS (Hypertext Transfer Protoc
ol Secure) can
provide more secure communication with the SSL/TLS
protocol, which support data encryption to HTTP clients
and servers.
Enable to allow Web access by HTTPS protocol.
HTTPS Port Specify the port for HTTPS. It can be 443 (default) or
from 1024 to 65535.
From Wireless Enable wireless devices to connect to access point’s
admin page. Disabled by default.
Access Control
By default, no IP addresses are prohibited from
accessing the device’s admin page. You can enable
access control and enter s
pecified IP addresses for
access. Four IPv4 and four IPv6 addresses can be
specified.
SNMP Settings
SNMP
Simple Network Management Protocol (SNMP) is a
network monitoring and management protocol.
Enable or disable SNMP function here. Disabled by
default.
Contact Enter contact information for the access point.
The contact includes 1 to 32 characters. Special
characters are allowed.
Location Enter the area or location where the access point
resides.
The location includes 1 to 32 characters. Special
characters are allowed.
SNMPv1/v2 Settings
Get Community
Enter the name of Get Community. Get Community is
used to read data from the access point and not for
writing data into the access point.
Get Community includes 1 to 32 characters. Special
characters are allowed.