User Guide

ManualsBrandsLinksys ManualsNetworkingLAPN300

Table Of Contents

Chapter 1 - LAPN300
- Mounting Guide
  - Wall Installation
  - Ceiling Installation
Chapter 2 – Access Point Setup
- Overview
- Set up using a web browser
- Setup wizard
Administration
- User accounts
- Time
- Log settings
- Management access
- SSL certificate
- LED
User Level
New Password
Confirm New Password
Automatically
LAN
- Network setup
- Advanced
Wireless
- Basic Settings
- Security
  - Security Mode
- Rogue AP Detection
- Scheduler
- Scheduler Association
- Connection Control
- Rate Limit
- Quality of Service (QoS)
- WDS
- Workgroup Bridge
- Advanced Settings
Select SSID
Primary Server
Primary Server Port
Primary Shared Secret
Backup Server
Backup Server Port
Backup Shared Secret
Captive Portal
- Global Configuration
- Portal Profiles
- Local User
- Local Group
- Web Customization
- Profile Association
- Client Information
MAC Address
IP Address
User Name
SSID Name
Online Time
Away Timeout
Session Timeout
Cluster
- Settings & Status
  - Master
- Client Sessions
- Channel Management
System Status
- System Summary
- LAN Status
- Wireless Status
- Wireless Clients
- Statistics
- Log View
Maintenance
- Firmware Upgrade
- Configuration Backup/Restore
- Factory Default
- Reboot
- Ping Test
- Packet Capture
- Diagnostic Log
Appendix A – Troubleshooting
- Overview
- General Problems
Appendix B – About Wireless LANs
- Overview
- Wireless LAN Terminology
Appendix C – PC and Server Configuration
- Overview
- Using WEP
- Using WPA2-PSK
- Using WPA2-Enterprise
  - Wireless Station Configuration
  - RADIUS Server Configuration
- 802.1x Server Setup (Windows 2000 Server)
- 802.1x Client Setup on Windows XP
- Using 802.1x Mode (without WPA)

LED

Enable or disable the LED on the top cover of LAPN300.

LED

LED Display

If disabled, the LED will be off even when the access

point is working. By default, LED is enabled (on).