User Guide
Table Of Contents
- Chapter 1 - LAPN300
- Chapter 2 – Access Point Setup
- Administration
- User Level
- New Password
- Confirm New Password
- Automatically
- LAN
- Wireless
- Select SSID
- Primary Server
- Primary Server Port
- Primary Shared Secret
- Backup Server
- Backup Server Port
- Backup Shared Secret
- Captive Portal
- MAC Address
- IP Address
- User Name
- SSID Name
- Online Time
- Away Timeout
- Session Timeout
- Cluster
- System Status
- Maintenance
- Appendix A – Troubleshooting
- Appendix B – About Wireless LANs
- Appendix C – PC and Server Configuration
25
Untagged
VLAN
Enables or disables VLAN tagging. If enabled (default),
traffic is untagged when VLAN ID is equal to Untagged
VLAN ID and untagged traffic can be accepted by LAN port.
If disabled, traffic from the LAN port is always tagged and
only tagged traffic can be accepted from LAN port.
By default all traffic on the access point uses VLAN 1, the
default untagged VLAN.
Untagged
VLAN ID
Specifies a number between 1 and 4094 for the untagged
VLAN ID. The default is 1. Traffic on the VLAN that you
specify in this field is not be tagged with a VLAN ID when
forwarded to the network.
Untagged VLAN ID field is active only when untagged VLAN
is enabled.
VLAN 1 is the default for untagged VLAN.
Management
VLAN
The VLAN associated with the IP address you use to
connect to the access point. Provide a number between 1
and 4094 for the Management VLAN ID. The default is 1.
IPv4/v6
IP Settings
Select Automatic Configuration or Static IP Address.
IP Address
Enter an unused IP address from the address range used on
your LAN.
Subnet Mask
Enter the subnet mask for the IP address above.
Default
Gateway
Enter the gateway for the IP address above.
Primary DNS
Enter the DNS address.
Secondary
DNS
Optional. If entered, this DNS will be used if the Primary
DNS does not respond.