User Guide
Table Of Contents
- Chapter 1 - LAPN300
- Chapter 2 – Access Point Setup
- Administration
- User Level
- New Password
- Confirm New Password
- Automatically
- LAN
- Wireless
- Select SSID
- Primary Server
- Primary Server Port
- Primary Shared Secret
- Backup Server
- Backup Server Port
- Backup Shared Secret
- Captive Portal
- MAC Address
- IP Address
- User Name
- SSID Name
- Online Time
- Away Timeout
- Session Timeout
- Cluster
- System Status
- Maintenance
- Appendix A – Troubleshooting
- Appendix B – About Wireless LANs
- Appendix C – PC and Server Configuration
84
Firmware Upgrade
The firmware (software) in the wireless access point can be upgraded by using HTTP/HTTPS, or TFTP.
Check the Linksys support website (http://www.linksys.com/support
) and download the latest
firmware release to your storage such as PC. Then, perform firmware upgrade by
following the steps below.
During firmware upgrade, do not power off device or disconnect the Ethernet cable. The access point
will reboot automatically after firmware upgrade is completed.
Figure 46: Firmware Upgrade Screen
To perform the firmware upgrade from local PC:
1.
Click the
Browse
button and navigate to the location of the upgrade file.
2.
Select the upgrade file. Its name will appear in the
Upgrade File
field.
3.
Click the
Upgrade
button to commence the firmware upgrade.
To perform the firmware upgrade from TFTP server:
1.
Enter the IPv4 address of the TFTP server and the source file. The source file is the firmware
filename you stored in your TFTP server.
2.
Click the
Upgrade
button to commence the firmware upgrade.