User Guide
Table Of Contents
- Chapter 1 – Getting Started
- Chapter 2 – System Status
- Chapter 3 – Quick Start
- Chapter 4 – System Management
- Chapter 5 – Port Management
- Chapter 6 – VLAN Management
- Chapter 7 - Spanning Tree Management
- Chapter 8 - MAC Address Management
- Chapter 9 – Multicast
- Chapter 10 - IP Interface
- Chapter 11 - IP Network Operations
- Chapter 12 – Security
- Chapter 13 - Access Control List
- Chapter 14 - Quality of Service
- Chapter 15 - Maintenance
- Chapter - 16 Support
49
Chapter 5 – Port Management
Ports
To configure port settings:
1.
Click Configuration > Port Management > Ports.
2.
Select
Enable
to support jumbo packets of up to 10 KB in size. If Jumbo Frames is not
enabled (default), the system supports packet size up to 2,000 bytes. For Jumbo Frames
to take effect, the device must be rebooted after the feature is enabled.
3.
To update the port settings, select the desired port, and click Edit.
•
Select Your Port
o
Port—Select the port number from the drop-down menu.
•
Port settings
o
Operational Status—Displays whether the port is up or down. If the
port is down because of an error, the description of the error is
displayed.
o
Administrative Mode—Select to change the operational status.
o
Suspended Port—Select to reactivate a port that has been suspended.
The reactivate operation brings the port up without regard to why the
port was suspended.