User Guide
Table Of Contents
- Chapter 1 – Getting Started
- Chapter 2 – System Status
- Chapter 3 – Quick Start
- Chapter 4 – System Management
- Chapter 5 – Port Management
- Chapter 6 – VLAN Management
- Chapter 7 - Spanning Tree Management
- Chapter 8 - MAC Address Management
- Chapter 9 – Multicast
- Chapter 10 - IP Interface
- Chapter 11 - IP Network Operations
- Chapter 12 – Security
- Chapter 13 - Access Control List
- Chapter 14 - Quality of Service
- Chapter 15 - Maintenance
- Chapter - 16 Support
67
o
Port Description—Information about the port, including manufacturer,
product name and hardware/software version.
o
System Name—System's assigned name (in alpha-numeric format). The
value equals the sysName object.
o
System Description—Description of the network entity (in alpha-numeric
format). This includes the system's name and versions of the hardware,
operating system, and networking software supported by the device. The
value equals the sysDescr object.
o
System Capabilities—Primary functions of the device, and whether or not
these functions are enabled on the device. The capabilities are indicated by
two octets. Bits 0 through 7 indicate Other, Repeater, Bridge, WLAN AP,
Router, Telephone, DOCSIS cable device, and station respectively. Bits 8
through 15 are reserved.
o
802.3 MAC-PHY—Duplex and bit rate capability and the current duplex
and bit rate settings of the sending device. It also indicates whether the
current settings are due to auto-negotiation or manual configuration.
o
802.3 Link Aggregation—Whether the link (associated with the port on
which the LLDP PDU is transmitted) can be aggregated. It also indicates
whether the link is currently aggregated, and if so, provides the aggregated
port identifier.
o
802.3 Maximum Frame—Maximum frame size capability of the MAC/PHY
Management Address TLV—Select one of the following ways to advertise
the IP management address of the device:
o
Auto Advertise—Specifies that the software automatically chooses a
management address to advertise from all the IP addresses of the device.
In case of multiple IP addresses, the software chooses the lowest IP
address among the dynamic IP addresses. If there are no dynamic
addresses, the software chooses the lowest IP address among the static IP
addresses.
o
None—Do not advertise the management IP address.
o
Manual Advertise—Select this option and the management IP address to
be advertised.
•
Management IP Address—If Manual Advertise was selected, select the
Management IP address from the addresses provided.
4.
Enter the relevant information, and click Apply. The port settings are written to the
Running Configuration file.