Owner's Manual

58
VLAN ID Displays the VLAN ID.
Querier State Select whether to enable or disable the MLD querier state for
the specified VLAN ID.
A querier can periodically ask their hosts if they wish to receive
multicast traffic. The querier feature will check whether hosts
wish to receive multicast traffic when enabled. An elected
querier will assume the role of querying the LAN for group
members, and then propagates the service requests on to any
upstream multicast Switch to ensure that it will continue to
receive the multicast service. This feature is only supported for
IGMPv1 and v2 snooping.
Querier Version Enter the version of MLD packet that will be sent by this port. If
an IGMP packet received by the port has a version higher than
the specified version, this packet will be dropped.
Querier Status The role of the switch in our network topology, querier or
nonquerier
Interval Enter the amount of time in seconds between general query
transmissions. The default is 125 seconds.
Group List
The Group List displays the VLAN ID, IPv6 address, and members port in the MLD Snooping List.
Router Settings
The Router Settings feature shows the learned multicast router attached port if the port is active
and a member of the VLAN. Select the VLAN ID you would like to configure and enter the static
and forbidden ports for the specified VLAN IDs that are utilizing MLD Snooping. All MLD packets
snooped by the Switch will be forwarded to the multicast router reachable from the port.