USER GUIDE Network Storage Link for USB 2.
About This Guide About This Guide Icon Descriptions While reading through the User Guide you may see various icons that call attention to specific items. Below is a description of these icons: NOTE: This check mark indicates that there is a note of interest and is something that you should pay special attention to while using the product. WARNING: This exclamation point indicates that there is a caution or warning and it is something that could damage your property or product.
Table of Contents Chapter 1: Product Overview 1 Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Back Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Chapter 2: Flash Disk Utility 3 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table of Contents Appendix F: Software License Agreement 23 Software in Linksys Products . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Software Licenses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Network Storage Link for USB 2.
Product Overview Chapter 1 Chapter 1: Product Overview Thank you for choosing the Network Storage Link for USB 2.0 Disk Drives. This stand-alone Network Attached Storage device features two USB ports. One port can be used for a USB Flash Drive, and the other can be connected to any USB hard drive. Front Panel DISK 2 (Green) This LED lights up when a flash disk or USB hard drive is connected. The LED flashes quickly to indicate that data is being transferred over your network.
Product Overview Chapter 1 DISK2 The Disk 2 port supports EXT3 and FAT32 file systems. Insert your USB flash drive (USB key) or USB disk here. DISK1 The Disk 1 port of the Network Storage Link supports EXT3, FAT32, and NTFS file systems. Connect your USB hard drive here. (Flash drives will not be recognized.) Reset The Reset button has two functions: •• If the Network Storage Link’s IP Address is lost, press and hold this button for two seconds. The IP Address will be set to the default value of 192.
Flash Disk Utility Chapter 2 Chapter 2: Flash Disk Utility 3. From this screen, select a Program Folder where you can access the utility. The utility will automatically be installed into the selected folder. Overview Before you can use a flash disk with the Storage Link, you will need to install this utility to install the Storage Link’s Utility into the System Tray of your Windows operating system. Installation 1. The Welcome screen will appear.
Configuration Chapter 3 Chapter 3: Configuration long. Enter this new password again in the Confirm new password field and click Save to save this new password. For advanced users, a web-based utility has been programmed into the Storage Link. This chapter will explain all of the functions in this web utility. All administrative tasks are performed through this web utility. The web utility can be accessed by any PC on the network by entering http://192.168.1.77 in the PC’s web browser Address window.
Configuration Chapter 3 Identification Server Name In this field, you can enter a new server name for the Storage Link. Punctuation and other special characters (e.g. * / | \ ) cannot be used in the name. Comment This field can be used to enter a comment, such as the Storage Link’s location. WorkGroup This should match your networked PC’s “Workgroup Name”.
Chapter 3 Configuration Properties Other Groups This shows all other Groups of which the user is not a member. This area of the screen allows you to change the properties for the user selected in the list above. To Add Membership to a Group Name The user’s name must be composed of alphanumeric symbols not exceeding 15 characters in length. Select the Group or Groups in the right-hand column, then click << . Multiple Groups can be selected by holding down the CTRL key while selecting.
Configuration Chapter 3 •• Click Restart Now to restart (reboot) the Storage Link. This will break all existing connections. The Storage Link will immediately restart, and will not be available again until after the restart is complete. None of your data will be saved. •• •Click View Log to view the log file in a separate window. The log file is a record of the Storage Link’s activity, which can help in management and troubleshooting. Click Refresh to refresh the screen.
Configuration Chapter 3 Administration > Shares Administration > Backup The Administration > Shares screen allows you to create and manage shares. The Administration > Backup screen allows you to back up the Storage Link’s configuration file to your PC and restore that configuration file to the Storage Link. The configuration file contains all network information, as well as the User, Group, and Share information. It does NOT include any information about the files stored on the Storage Link.
Configuration Chapter 3 Data Backup Data files can be backed up from the Storage Link to another network device, or from another network device to the Storage Link. The Backup Jobs field displays any backup jobs you have defined. If you have not defined any jobs, the field will be empty. For each job defined, the following data is shown. Name This shows the name you assigned to this backup job.
Configuration Chapter 3 Administration > Disk The Administration > Disk screen allows you to perform disk maintenance. Click Save to save the settings on this screen. This has no effect on any operations in progress. Click Cancel to restore the settings on the screen to their previous values. Clicking Cancel has no effect on operations in progress. Click Disk Log to view a log showing the results of the last Scandisk operation. Click Help to get more information about this screen.
Configuration Chapter 3 User Guide Tab Click this tab to open this User Guide in an online format. User Guide Linksys Web Tab Click this tab to open the Linksys website. Network Storage Link for USB 2.
Appendix A Troubleshooting Appendix A: Troubleshooting When I click the Storage Link’s icon in Network Neighborhood, I’m prompted for a password. The Storage Link Utility cannot detect the Storage Link. •• Your Windows Logon name is recognized by the •• Check that the Storage Linkis properly installed, that the LAN connections are secure, and that the Storage Link is powered ON. •• If you are using a router, make sure that your PC and the Storage Link are on the same network segment.
Using the Storage Link’s Storage Appendix B Appendix B: Using the Storage Link’s Storage Windows will then prompt you to log on to the Network when it boots. You must log on. If you press ESC, or click Cancel, no network resources will be available. When you log on, you need to use a valid User Name and Password. If the Network Storage Link Administrator has defined users on the Network Storage Link, use the User Name and password they supply.
Using the Storage Link’s Storage Appendix B Mapping the Network Drive 7. Click OK. This drive will now be available in Windows Explorer, and from the File, Open or File, Save As dialog box in all Windows applications. On Windows 95/98/ME, when you try to access a folder, you may be prompted for a password. If your Windows logon name is the same as your user name on the Storage Link, but the passwords are different, you can enter your Storage Link password here.
Specifications Appendix C Appendix C: Specifications Model NSLU2 Standards IEEE 802.3, IEEE 802.3u, USB 1.1, USB 2.0 Protocols SMB/CIFS over TCP/IP Ports One 10/100 Mbps RJ-45, Power, Two USB 2.0 Cabling Type UTP CAT 5 or better Topology Star LEDs Ready/Status, Ethernet, Disk 2, Disk 1 Switches Power, Reset Environmental Dimensions 27,5 x 135 x 96 mm Weight 185 g Power 5V DC, Maximum 2 Amps Certifications FCC Class B, CE, VCCI Operating Temp.
Appendix D Appendix D: Warranty Information Limited Warranty Linksys warrants that this Linksys hardware product will be substantially free of defects in materials and workmanship arising under normal use during the Warranty Period, which begins on the date of purchase by the original enduser purchaser and lasts for the period specified below: •• Two (2) years for new product •• Ninety (90) days for refurbished product This limited warranty is non-transferable and extends only to the original end-user pur
Appendix D Warranty Information and a copy of your dated proof of original purchase when returning your product. Products received without a RMA number and dated proof of original purchase will be rejected. Do not include any other items with the product you are returning to Linksys. Defective product covered by this limited warranty will be repaired or replaced and returned to you without charge.
Regulatory Information Appendix E Appendix E: Regulatory Information FCC Statement This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Appendix E User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of Linksys products.
Appendix E Regulatory Information Eesti (Estonian) - Keskkonnaalane informatsioon Euroopa Liidus asuvatele klientidele Français (French) - Informations environnementales pour les clients de l’Union européenne Euroopa Liidu direktiivi 2002/96/EÜ nõuete kohaselt on seadmeid, millel on tootel või pakendil käesolev sümbol , keelatud kõrvaldada koos sorteerimata olmejäätmetega. See sümbol näitab, et toode tuleks kõrvaldada eraldi tavalistest olmejäätmevoogudest.
Appendix E Regulatory Information Lietuvškai (Lithuanian) - Aplinkosaugos informacija, skirta Europos Sąjungos vartotojams Nederlands (Dutch) - Milieu-informatie voor klanten in de Europese Unie Europos direktyva 2002/96/EC numato, kad įrangos, kuri ir kurios pakuotė yra pažymėta šiuo simboliu (įveskite simbolį), negalima šalinti kartu su nerūšiuotomis komunalinėmis atliekomis. Šis simbolis rodo, kad gaminį reikia šalinti atskirai nuo bendro buitinių atliekų srauto.
Appendix E Regulatory Information Português (Portuguese) - Informação ambiental para clientes da União Europeia Slovenščina (Slovene) - Okoljske informacije za stranke v Evropski uniji A Directiva Europeia 2002/96/CE exige que o equipamento que exibe este símbolo no produto e/ou na sua embalagem não seja eliminado junto com os resíduos municipais não separados. O símbolo indica que este produto deve ser eliminado separadamente dos resíduos domésticos regulares.
Appendix F Appendix F: Software License Agreement Software in Linksys Products This product from Cisco-Linksys LLC or from one of its affiliates Cisco Systems-Linksys (Asia) Pte Ltd. or CiscoLinksys K.K. (“Linksys”) contains software (including firmware) originating from Linksys and its suppliers and may also contain software from the open source community. Any software originating from Linksys and its suppliers is licensed under the Linksys Software License Agreement contained at Schedule 1 below.
Software License Agreement Appendix F your Linksys product and/or the Software is being used in accordance with the terms of this Agreement; (iii) to provide improvements to the way Linksys delivers technology to you and to other Linksys customers; (iv) to enable Linksys to comply with the terms of any agreements it has with any third parties regarding your Linksys product and/or Software and/or (v) to enable Linksys to comply with all applicable laws and/or regulations, or the requirements of any regulat
Appendix F GNU General Public License is intended to guarantee your freedom to share and change free software–to make sure the software is free for all its users. This General Public License applies to most of the Free Software Foundation’s software and to any other program whose authors commit to using it. (Some other Free Software Foundation software is covered by the GNU Lesser General Public License instead.) You can apply it to your programs, too.
Appendix F c. If the modified program normally reads commands interactively when run, you must cause it, when started running for such interactive use in the most ordinary way, to print or display an announcement including an appropriate copyright notice and a notice that there is no warranty (or else, saying that you provide a warranty) and that users may redistribute the program under these conditions, and telling the user how to view a copy of this License.
Software License Agreement Appendix F 7. If, as a consequence of a court judgment or allegation of patent infringement or for any other reason (not limited to patent issues), conditions are imposed on you (whether by court order, agreement or otherwise) that contradict the conditions of this License, they do not excuse you from the conditions of this License.
Appendix F GNU LESSER GENERAL PUBLIC LICENSE Version 2.1, February 1999 Copyright (C) 1991, 1999 Free Software Foundation, Inc. 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA Everyone is permitted to copy and distribute verbatim copies of this license document, but changing it is not allowed. [This is the first released version of the Lesser GPL. It also counts as the successor of the GNU Library Public License, version 2, hence the version number 2.1.
Appendix F freedom and the wherewithal to run that program using a modified version of the Library. The precise terms and conditions for copying, distribution and modification follow. Pay close attention to the difference between a “work based on the library” and a “work that uses the library”. The former contains code derived from the library, whereas the latter must be combined with the library in order to run.
Appendix F Thus, it is not the intent of this section to claim rights or contest your rights to work written entirely by you; rather, the intent is to exercise the right to control the distribution of derivative or collective works based on the Library. In addition, mere aggregation of another work not based on the Library with the Library (or with a work based on the Library) on a volume of a storage or distribution medium does not bring the other work under the scope of this License. 3.
Appendix F Software License Agreement b) Use a suitable shared library mechanism for linking with the Library. A suitable mechanism is one that (1) uses at run time a copy of the library already present on the user’s computer system, rather than copying library functions into the executable, and (2) will operate properly with a modified version of the library, if the user installs one, as long as the modified version is interface-compatible with the version that the work was made with. 8.
Software License Agreement Appendix F software distributed through that system in reliance on consistent application of that system; it is up to the author/donor to decide if he or she is willing to distribute software through any other system and a licensee cannot impose that choice. This section is intended to make thoroughly clear what is believed to be a consequence of the rest of this License. 12.
Appendix F Software License Agreement OpenSSL License Original SSLeay License Copyright © 1998-2007 The OpenSSL Project. All rights reserved. Copyright © 1995-1998 Eric Young (eay@cryptsoft.com)All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: This package is an SSL implementation written by Eric Young (eay@cryptsoft.com). 1.
Appendix F Software License Agreement DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
