Instruction Manual

5. Click Save to create the IPP port on your system. You will see a message

confirming that the port has been created and then Figure 8-2.

6. Perform one of these steps. Select an existing printer to use the new port, and

click OK.

Click the Add New Printer button to create a new printer to use the IPP

port. This will start the Add Printer Wizard. Follow the prompts to complete

the process. Make sure that the new printer uses the IPP port.

Installation is now complete.

· To create additional IPP ports, repeat the entire procedure.

· The Proxy Server and other options are set individually for each IPP Port.

Changing the IPP Port Settings

After the IPP port is created, you can reach the Configure IPP Port screen by

performing these steps:

EtherFast

Wireless-Ready USB PrintServer

IPP Client Configuration for Windows 95, 98, Millennium, NT 4.0, 2000,

and XP

1. Run the Add IPP Port program entry created by the installation. A screen

like the one shown in Figure 8-1 will be displayed.

2. If Internet access from your location is via a Proxy Server, check Access IPP

Server via Proxy Server, and enter details of your Proxy Server. (This will

be the same as your Browser configuration.)

3. Enter the IP Address or URL of the IPP Server.

4. Click Select Device Port to view the available ports on the IPP Server, and

select the appropriate port. A connection to the IPP Server will be estab-

lished at this time.

Note: Verify that USB 1 appears in the field beside the Select Device

Port button. If it does not, click the Select Device Port button, and

select USB 1.

Instant EtherFast

Series

Figure 8-1

Figure 8-2