User Manual
Table Of Contents
- Chapter 1: Planning Your Network
- Chapter 2: Getting to Know the Wireless-G ADSL Gateway with 2 Phone Ports
- Chapter 3: Connecting the Wireless-G ADSL Gateway
- Chapter 4: Configuring the Gateway
- Chapter 5: Using the Linksys Parental Control Service
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Configuring IPSec between a Windows 2000 or XP Computer and the Gateway
- Appendix D: Finding the MAC Address and IP Address for Your Ethernet Adapter
- Appendix E: Upgrading Firmware
- Appendix F: Windows Help
- Appendix G: Glossary
- Appendix H: Specifications
- Appendix I: Warranty Information
- Appendix J: Regulatory Information
- Appendix K: Contact Information
117
Appendix J: Regulatory Information
Wireless-G ADSL Gateway with 2 Phone Ports
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Linksys declares that WAG54GP2 V2- Annex A (FCC ID: Q87-WAG54GP2V2 ) is limited in CH1~ CH11 for 2.4 GHz by
specified firmware controlled in U.S.A.
INDUSTRY CANADA (CANADA)
This device complies with Industry Canadia ICES-003 and RSS210 rules.
Cet appareil est conforme aux normes NMB-003 et RSS210 d'Industrie Canada.
The use of this device in a system operating either partially or completely outdoors may require the user to obtain
a license for the system according to the Canadian regulations.
IMPORTANT NOTE:
IC Radiation Exposure Statement:This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with IC RF exposure compliance requirements, please avoid direct contact to
the transmitting antenna during transmitting.This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
SAFETY NOTICES
Caution: To reduce the risk of fire, use only No.26 AWG or larger telecommunication line cord.
Do not use this product near water, for example, in a w et basement or near a swimming pool.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Operation is subject to the following two conditions:
1) This device may not cause interference and 2) This device must accept any interference, including interference that may
cause undesired operation of the device.