Owner's Manual

6
Chapter 3: Getting to Know the Wireless-G Cable Gateway
The Back Panel
Wireless-G Cable Gateway
Chapter 3: Getting to Know the Wireless-G Cable Gateway
The Back Panel
The Gateway’s buttons and ports, where network cables are connected, are located on the back panel.
On/Off Switch This switch is used for turning the Gateway on and off.
Power The Power port is where you will connect the power adapter.
Reset Press this button and hold it in for five seconds to restore the Gateway to its factory default
settings.
Ports 1-4 These four ports are used to connect network devices, such as PCs, print servers, and remote
hard drives to your local area network (LAN).
USB This is where you can use a USB cable to connect the Gateway.
Cable The Cable port is where you will connect your coaxial Cable line.
IMPORTANT: Resetting the Gateway to factory
defaults will erase all of your settings (Internet
connection, wireless, security, and other
settings) and replace them with the factory
defaults. Do not reset the Gateway if you want
to retain these settings.
Figure 3-1: Back Panel