Quick Start Manual

Model No.
Quick Installation
A Division of Cisco Systems, Inc.
®
Model No.
Voice
IP Phone
Package Contents
• Handset
• Power Adapter
• Quick Installation
•User Guide on CD-ROM
12
Inserting the Battery Powering on the IP Phone
NOTE: The following are descriptions
of your navigation choices:
Navigation Pad - Scroll through
menu choices
Center Selection Key - Make
selections or save changes
Clear Soft Key - Use for a
backspace
Exit Soft Key - Cancel changes
and return to the previous screen
To insert the battery, follow these
instructions:
A Remove the cover of the
battery compartment. Push
down on the button and
slide the cover downward.
B Insert the battery. Make sure
the metal contacts of the
battery line up with the
metal contacts of the
battery compartment.
C Insert the door and slide it
upward until it snaps into
place.
Make sure you have the account
information, including necessary
IP Phone settings, supplied by your
Internet phone service provider.
If you already have an account
set up with your Internet phone
service provider, then proceed to
step A. If you do not have an
account, then go to the website
of your Internet phone service
provider and sign up for service.
Proceed to step A.
A Plug the USB mini-B
connector of the included
power adapter into the USB
mini-B port of the IP Phone.
Then connect the power
adapter to a standard
electrical outlet.
B The power LED will flash,
alternating between blue
and purple.
Before you begin, make sure your
network has an active Internet
connection.
A Press the Power button for
two seconds.
B The IP Phone will scan for
wireless networks and then
display a list of networks.
Scroll through the list, and
press the center selection
key to select a network.
If the network you want is
not shown, select Rescan.
C The IP Phone will
automatically connect to
the network.
If WEP security is enabled,
select the appropriate
transmit key from the Key
Index, and then enter the
network’s WEP key. Press the
center selection key.
WIP330
Wireless-G
A
Button
Metal Contacts
B
3
Setting Up the IP Phone
B1
B2
WEP
If WPA security is enabled,
then enter the network’s
WPA key. Press the center
selection key.
D You will be notified when the
IP Phone has connected to
the network, and a
checkmark will appear next
to the name of the network.
Select Exit.
E The standby screen will
appear. Select Menu.
F Phone Settings will be
highlighted. Navigate the
menu choices, and then
select SIP Settings.
D
E
F
Headset
Jack
USB Port
WPA
Power LED
Soft Key
Power or
End Call
Soft Key
Navigation Pad
and Center
Selection Key
Call
NOTE: For the initial charge,
allow the battery to charge
for at least 10 hours.
C
Enter Symbol
or Space
Different Key
Choices or + Sign

Summary of content (2 pages)