User Guide

ManualsBrandsLinksys ManualsNetwork CardWPS54G

A Division of Cisco Systems, Inc.

Model No.

Quick Installation

Model No.

Wireless

WPS54G

PrintServer

Wireless-G

Package Contents

• Wireless-G PrintServer

• Setup Wizard CD-ROM

•User Guide on CD-ROM

•USB 2.0 Cable

•Network Cable

• Power Supply

• Quick Installation

• Registration Card

Before starting the physical

installation, note the PrintServer’s

default name. The default name is

shown in the Server field on the

sticker located on the PrintServer’s

back panel.

A Use the USB cable to connect

your USB printer to the

PrintServer’s USB Printer port.

B If you are connecting the

PrintServer to your wired

network, then plug one end of

the Ethernet network cable into

the PrintServer’s Ethernet port.

Then connect the other end to

your router or switch.

C Power on your printer.

D Plug the power adapter into

the PrintServer’s Power port.

Then plug the other end into

an electrical outlet.

Connect the PrintServer

E The IP Settings screen will

appear. If your network uses a

router that automatically

assigns IP addresses, select

Automatically obtain an IP

address (DHCP) and click

Next. If you need to assign the

PrintServer a static IP address,

select Set IP configuration

manually, and enter the IP

Address, Subnet Mask, and

Gateway in the fields provided.

Then click Next.

F On the Set PrintServer’s

Password screen, enter the

PrintServer’s default password,

admin, in the Current

Password field. Enter a new

password in the New Password

field, and enter it again in the

Verify Password field.

Click Next.

G On the Wireless Settings

screen, enter your wireless

network’s SSID or name. If your

network is set to ad-hoc mode,

select the channel at which

the network broadcasts its

wireless signal. For the Network

Type setting, select

infrastructure if the PrintServer

will communicate using an

access point or wireless router.

Select Ad-Hoc if the PrintServer

will communicate directly with

wireless-equipped computers.

Click Next.

Configure the PrintServer

Insert the Setup CD-ROM into

the computer’s CD-ROM drive.

The Setup Wizard should run

automatically. If it does not,

click Start and choose Run. In

the field that appears,

enter D:\setupWizard.exe (if

“D” is the letter of your

CD-ROM drive).

B On the Welcome screen, click

Setup Wizard.

C The Setup Wizard will search for

the PrintServer. After it has been

found, the Wireless-G

PrintServer Setup screen will

appear. If this is the first time

you have run the Setup Wizard,

make sure that List only new

(unconfigured) Print Servers is

selected and your PrintServer is

listed by its default server

name. If you have previously

configured the PrintServer,

select List all compatible Print

Servers. Click Next.

D On the Basic Settings screen,

you may change the Device

Name and Domain Name

settings if you want. Then

click Next.

GHz

2.4

802.11g

Summary of content (2 pages)

PAGE 1
Connect the PrintServer 2 Configure the PrintServer ® A Division of Cisco Systems, Inc. A Before starting the physical installation, note the PrintServer’s default name. The default name is shown in the Server field on the sticker located on the PrintServer’s back panel. A B Use the USB cable to connect your USB printer to the PrintServer’s USB Printer port.
PAGE 2
3 H On the Wireless Security Settings screen, select a level of WEP encryption, 64 Bit Keys or 128 Bit Keys. Then enter a Passphrase to automatically generate a WEP key. Then click Next. If you would like to enter your WEP key manually, leave the Passphrase field blank and enter the WEP key on the next screen. Then click Next. I J K D Linksys recommends that you set up your printer and install your printer’s driver before you install the PrintServer’s driver.