Datasheet
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Chapter J: Contact Information
15
Chapter 5: Windows Driver Installation
Installation
Wireless-G PrintServer for USB 2.0
6. The Select Program Folder screen will appear, as shown in Figure 5-4. An icon will be added to the program
folder listed. You may change the name for the program folder, if you wish. Click Next.
Click Back to return to the previous screen. Click Cancel to end the driver installation.
7. When the driver is installed, the Setup Complete screen, Figure 5-5, will appear. The Print Driver must still be
configured, so make sure that Configure Print Driver now is selected. Click Finish to end the driver
installation and begin the driver configuration.
Figure 5-4: Select Program Folder
Figure 5-5: Setup Complete