Datasheet
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Chapter J: Contact Information
16
Chapter 5: Windows Driver Installation
Starting the Print Driver Utility
Wireless-G PrintServer for USB 2.0
Starting the Print Driver Utility
1. Click Start, Programs, Print Server Utility, and then Print Driver Setup. If the Print Driver Setup icon has
been created, you can double-click it instead.
2. The Information screen will appear; see Figure 5-6. Read the on-screen information, and then click OK.
3. The Printer Port Setup screen will appear, as shown in Figure 5-7, and list the PrintServer and its ports. Select
a printer port to add, and then click Next.
If the PrintServer or printer isn’t listed, make sure that the cable connections are good and the PrintServer
and printer are powered on.
4. You will be informed that the PrintServer Port has been added successfully. Click OK.
Figure 5-7: Printer Port Setup
Figure 5-6: Information