Datasheet
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Chapter J: Contact Information
17
Chapter 5: Windows Driver Installation
Starting the Print Driver Utility
Wireless-G PrintServer for USB 2.0
5. The Configure Printer Port screen will appear, as shown in Figure 5-8. Your installed printer(s) will appear in
the field. Select the printer you want, and click the Connect button to associate the printer with your selected
printer port. To add another printer, click the Add New Printer button.
Click Cancel to cancel the setup.
6. Click Close to close the Printer Port Setup screen. Click Refresh to refresh the screen.
7. The driver installation and configuration is complete. You can now use the PrintServer.
If you would like to change the PrintServer’s settings, use the PrintServer’s web-based utility. For more
information, refer to “Chapter 6: Configuring the PrintServer Using the Web-based Utility.”
Figure 5-8: Configure Printer Port