Datasheet
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Chapter J: Contact Information
26
Chapter 6: Configuring the PrintServer Using the Web-based Utility
The Status Tab - Device
Wireless-G PrintServer for USB 2.0
The Status Tab - Device
The Device tab allows you to view information about the PrintServer. No values can be changed on this screen.
This screen is for information only. (See Figure 6-11.)
Clicking the Refresh button causes the PrintServer to retrieve this information again.
The Status Tab - Printer
The Printer tab allows you to view information about the Printers. No values can be changed on this screen. This
screen is for information only. (See Figure 6-12.)
Click the Print Test Page button to print a test page on the respective printer.
Clicking the Refresh button causes the PrintServer to retrieve the status information again.
Figure 6-11: Status Tab - Device
Figure 6-12: Status Tab - Printer