Datasheet
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Chapter J: Contact Information
27
Chapter 6: Configuring the PrintServer Using the Web-based Utility
The Status Tab - Wireless
Wireless-G PrintServer for USB 2.0
The Status Tab - Wireless
The Wireless tab allows you to view information about the PrintServer’s wireless connection. No values can be
changed on this screen. This screen is for information only. (See Figure 6-13.)
Clicking the Refresh button causes the PrintServer to retrieve information about the wireless connection again.
The Exit Tab
This tab is used exclusively for exiting the Web-based Utility.
Select the Exit tab, and the screen in Figure 6-14 will appear. Click the Yes button if you want to exit the Utility.
Click No if you don’t want to exit the Utility.
Figure 6-13: Status Tab - Wireless
Figure 6-14: Exit