User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
15
Chapter 4: Configuring the PrintServer Using the Setup Wizard
Installation
Wireless-G PrintServer with Multifunction Printer Support
15. If your network uses wireless security, you will prompted to enter the correct information.
If you enter a Passphrase, you will see the automatically generated WEP key on the following screen.
Otherwise, enter the WEP key manually in the field provided. If you are using 64-bit WEP encryption, then the
key must consist of exactly 10 hexadecimal characters. If you are using 128-bit WEP encryption, then the key
must consist of exactly 26 hexadecimal characters. Valid hexadecimal characters are “0”-“9” and “A”-“F”.
Click Next to continue, or click Back to return to the previous screen.
Figure 4-15: Wireless Security Settings - Disabled
Figure 4-16: Wireless Security - WEP