User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
22
Chapter 5: Windows Driver Installation
Configuration of the PrintServer Driver
Wireless-G PrintServer with Multifunction Printer Support
Configuration of the PrintServer Driver
1. The Wireless-G PrintServer Driver screen automatically appears. Select the PrintServer you are installing.
Then click Next.
2. The Checking Printer Driver screen appears. Select the driver for your printer, and click Next to continue.
If the driver for your printer is not installed, you will see a new window pop up. The message will ask you to
exit the Wizard and install the driver for your printer. Click OK and install the driver. After the driver has been
installed, run the Setup Wizard and click Driver Install on the Welcome screen.
Figure 5-4: Check Print Driver
Figure 5-3: Select Printer
NOTE: If the PrintServer is not listed, then click Refresh. If the PrintServer cannot be found, then
select to temporarily disable the firewall and click Refresh again.