User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
23
Chapter 5: Windows Driver Installation
Configuration of the PrintServer Driver
Wireless-G PrintServer with Multifunction Printer Support
3. The Wireless-G PrintServer Driver screen appears. Review the PrintServer status and then click Next.
4. The Wireless-G PrintServer Driver screen appears. If you want to print a test page, click Test Print. Then click
Finish.
5. If you’ve chosen to print a test page, the test page dialog appears. Click OK.
Figure 5-5: Wireless-G PrintServer Diagnostic - Check
Printer Driver Installation
Figure 5-6: Printer Driver Not Installed
Figure 5-7: Print Test Page