User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
26
Chapter 6: Configuring the PrintServer Using the Web-based Utility
The Setup Tab
Wireless-G PrintServer with Multifunction Printer Support
The Setup Tab
The first screen that appears is the Setup tab and allows you to change the PrintServer’s general settings.
WPS54G Device Name
Enter the PrintServer’s name in the field provided. The name is located on a sticker on the bottom of the
PrintServer.
Password
Current Password. To change the PrintServer’s password, enter the current password in the Current Password
field.
New Password and Verify Password. Enter the new password in the New Password field, and then enter the
new password again in the Verify Password field.
Protocols
The TCP/IP protocol is enabled by default.
Enable: Apple Talk or NetBEUI. Check the box(es) for AppleTalk or NetBEUI, if they are used by your network.
Click the Save button to apply your changes, or click Cancel to cancel your changes.
Figure 6-1: Setup Tab