User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
31
Chapter 6: Configuring the PrintServer Using the Web-based Utility
The Wireless Tab - Basic
Wireless-G PrintServer with Multifunction Printer Support
The Wireless Tab - Basic
This screen allows you to change the PrintServer’s basic wireless settings.
Configuration
Regulatory Domain and MAC Address. The PrintServer’s Regulatory Domain and MAC Address are listed and
cannot be changed.
SSID. In the SSID field, enter the name of your wireless network. This is the unique name shared by all devices in
a wireless network. The SSID is case-sensitive and should have 32 characters or fewer.
Channel No. If your network is set to ad-hoc mode, select your network’s channel setting from the Channel No.
drop-down menu.
Network Type. The Network Type setting shows a choice of two wireless modes. Select Infrastructure if you
want the PrintServer to communicate using an access point or wireless router. Select Ad-Hoc if you want the
PrintServer to communicate without using an access point or wireless router.
Click the Save button to apply your changes, or click Cancel to cancel your changes.
Figure 6-6: Wireless Tab - Basic