User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
38
Wireless-G PrintServer with Multifunction Printer Support
Chapter 7: Bi-Admin Management
Bi-Admin Installation
5. The Choose Destination Location screen will appear. Choose the location where the B-Admin folder will be
installed. To install the driver in the default location, click Next. If you want the folder to be installed in a
different location, click the Browse button and select the location. Then click Next.
Click Back to return to the previous screen. Click Cancel to end the Bi-Admin installation.
6. The Select Program Folder screen will appear. An icon will be added to the program folder listed. You may
change the name for the program folder, if you wish. Click Next.
Click Back to return to the previous screen. Click Cancel to end the Bi-Admin installation.
7. When the Bi-Admin is installed, the Setup Complete screen will appear. Click Finish.
Figure 7-4: Select Program Folder
Figure 7-3: Choose Destination Location