User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Getting to Know the PrintServer
- Chapter 3: Connecting the PrintServer
- Chapter 4: Configuring the PrintServer Using the Setup Wizard
- Chapter 5: Windows Driver Installation
- Chapter 6: Configuring the PrintServer Using the Web-based Utility
- Chapter 7: Bi-Admin Management
- Chapter 8: Internet Printing Protocol (IPP)
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: About Bi-Directional Printing
- Appendix D: Upgrading Firmware
- Appendix E: Windows Help
- Appendix F: Glossary
- Appendix G: Specifications
- Appendix H: Warranty Information
- Appendix I: Regulatory Information
- Appendix J: Contact Information
62
Appendix D: Upgrading Firmware
Wireless-G PrintServer with Multifunction Printer Support
Appendix D: Upgrading Firmware
Use the PrintServer’s Web-based Utility to upgrade its firmware. Follow these instructions:
1. Visit www.linksys.com and download the firmware upgrade file for the Wireless-G PrintServer with
Multifunction Printer Support.
2. Extract the file on your computer.
3. Open the PrintServer’s Web-based Utility.
4. Click the Status tab, and then click the Device tab.
5. On the Device screen, click the Upgrade button.
6. On the Firmware Upgrade screen, enter the location of the extracted firmware file, or click the Browse button
to find this file.
7. Click the Start Upgrade button, and follow the on-screen instructions.
Figure D-1: Status Tab - Device
Figure D-2: Firmware Upgrade