hear the beacons and awaken to receive the broadcast and multi cast messages. The default value is 1. Fragmentation Threshold This value specifies the maximum size for a packet before data is fragmented into multiple packets. If you experience a high packet error rate, you may slightly increase the Fragmentation Threshold, Setting the Fragmentation Threshold too low aay result in poor network performance. Only minor reduction of the default value is recommended.
FTP Pass through Point-few-Point Tunneling Protocol {PT} allows the Point-to-Point Protocol {PPP to be tunneled through an IP network. To allow PT tunnels to pass through the Router, keep the default, Enable. LATE Pass through Layer 2 Tunneling Protocol is the method used to enable Point-to-Point sessions via the internet on the Layer 2 level, To allow LETUP tunnels to pass through the Router, keep the default, Enable.
Ee Re Ee Blocked Services You can filter access to various services accessed over the internet, such as FTP or telnet, by selecting services from the drop-down menus next to Blocked Services. (You can block up to 20 services.) Then enter the range of ports you want to filter. if the service you want to block is not listed or you want to audit a service's settings, then click Add/Edit Service. Then the Port Services screen will appear. To add a service, enter the service's name in the Service Name field.
Ee Re Ee “Applications snd Gaming > Port Genghis Port Triggering Application Enter the application name of the trigger. Triggered Range For each application, list the triggered port number range. Check with the interment application documentation for the port number(s} needed. Start Port Enter the starting port number of the Triggered Range, End Port Enter the ending port number of the Triggered Range. Forwarded Range For each application, list the forwarded port number range.
Device Priority Enter the name of your network device in the Device Nome field, enter its MAC Address, and then select its priority from the drop-down menu. Ethernet Port Priority Ethernet Port Priority QoS allows you to prioritize performance for the Routers four ports, LAN Ports 1-4. For each port, select the priority and flow control setting. Priority Select High or Low in the Priority column, The Routers four ports have been assigned low priority by default.
Router Password Local Router Access Router Password Enter a new Password for the Router. Re-ante to confirm Enter the Password again to confirm, Web Access Harems Server HTTP {Hyper Text Transport Protocol} is the communications protocol used to connect to servers on the World Wide Web. HTTP uses SSL (Secured Socket Layer} to encrypt data transmitted for higher security, Select HTTP or HTTP. The default selection is HTTP.
Ee Re Ee and click Trace route. The Trace route Test screen will show if the test was successful. To stop the test, dick Step. Click Clear Log to clear the screen. Click Close to rectum to the Diagnostics screen, The Trace route Test Administration > Factory Defaults The Administration > Factory Defaults screen allows you to restore the Router’s configuration to its factory default settings.
Status > Router Reuters Information Firmware Version This is the Routers cement firmware, Currant Time This shows the time, as you set on the Setup tab. BAC Address This is the Routers MAC Address, as seen by your 58 Router Mams This is the specific name for the Router, which you set on the Sat up tab. Hast Mae If required by your ISP, this would have been entered on the Setup tab. Domain Name If required by your ISB this would have been entered on the Setup tab.
