User Guide Next-Gen AC Max-Stream AC600 Wi-Fi Micro USB Adapter WUSB6100M 1
Contents Product Overview ................................................................................................... 3 Installation ................................................................................................................. 4 Connect with Network Manager ........................................................................................................ 4 Troubleshooting ......................................................................................................
Product Overview The USB6100M adapter upgrades Wi-Fi connectivity on your Windows-based desktop or laptop computer. To help protect your data and privacy, you can configure your home network and this adapter to use Wi-Fi Protected Access 2 (WPA2) encryption. USB plug—Connect this end to any available USB port on your computer. LED—Blinks during WPS and is solid when connected to a Wi-Fi network.
Installation 1. Insert the USB adapter into an open USB port on your computer. 2. Watch your monitor/screen as the device automatically installs. 3. Connect to your Wi-Fi network using your computer’s network manager. Note—If the adapter did not install automatically, use the provided CD or download and run the driver installation file available at linksys.com/support/wusb6100m. Connect with Network Manager Choose your operating system. • Windows 10 • Windows 8.1 • Windows 7 Windows 10 1.
Troubleshooting Your computer does not recognize the adapter. • Make sure that the adapter is properly inserted into your computer’s USB port. • Connect the adapter into a different USB port. Your adapter’s LED is orange. • Your adapter has been disabled. • Go to your computer’s network settings page and make sure the adapter was installed. • Enable the adapter. Your computer cannot communicate with other computers on your Wi-Fi network. • Make sure that the computers are powered on.
Specifications Linksys WUSB6100M Model Name Next-Gen AC Max-Stream AC600 Wi-Fi Micro USB Adapter Model Number WUSB6100M Standards 802.11a, 802.11b, 802.11g, 802.11n, 802.11ac Interface USB 2.0 LED Connection Status Antennas 1 internal dual-band Security Features WEP, WPA and WPA2, Personal, WPA and WPA RADIUS Security Key Bits Up to 128-bit encryption OS requirements Windows 7, Windows 7 64-bit, Windows 8.1, Windows 8.
Notes: For regulatory, warranty, and safety information, see the CD that came with your USB adapter or go to Linksys.com/support/wusb6100m. Specifications are subject to change without notice. Maximum performance derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower Wi-Fi network capacity, data throughput rate, range and coverage.
FCC Federal Communications Commission (FCC) Statement 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
exposure guidelines when used with an accessory that contains no metal and that positions the device a minimum of 5mm from the body. Use of other accessories may not ensure compliance with RF exposure guidelines. Operation in the band 5150~5250MHz is only for indoor use. Cet appareil numérique de classe B est conforme à la norme NMB‐003 et RSS‐247 Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
