Owner's Manual

8
Chapter 3: Getting to Know and Using the Wireless-G Network Adapter with Wi-Fi Finder
Using the Wi-Fi Finder
Wireless-G USB Network Adapter with Wi-Fi Finder
ON/OFF Switch The ON/OFF switch is located on the side panel. Slide the button to the right side to turn on the
Wi-Fi Finder.
Scan The Scan button is located on the side panel. Push the Scan button to scan for a wireless
network.
There are three Wireless Network Scan Modes (shown in bottom right corner of screen):
A = All Networks (default mode), U = Unsecured Networks, S = Specific Network Name
To change the mode, push and hold the Scan button.
• All Networks: This default mode scans and displays all secure and unsecure networks.
• Unsecured Networks: This mode scans and displays only unsecured networks.
• Specific Network Name: This mode scans and displays any networks with a selected
specific network name. First, while in the All Networks mode, use the Scroll button and
scroll until the network that you want is on your screen, then push and hold the Scan
button to change the icon to S. Then, push the Scan button again to scan for any network
with the selected name.
Scroll The Scroll button is located on the side panel. Push the Scroll button to view the next available
wireless network, which will be displayed in the order of strongest to weakest signal strength.
A maximum of fifteen wireless networks can be viewed.
Figure 3-3: Wi-Fi Finder’s ON/OFF Switch and Buttons