User's Manual

Page 6

ContentsContents

Getting Started

Location of Main Unit Controls

1. ON/OFF / Pairing / Answer /

Reject call / Redial

2. Micro USB charging port

(not shown)

3. 3.5 mm input port

4. Microphone

5. LED

6. Previous song / Volume-

7. Play / Pause

8. Next song / Volume +

Page 7

Operational Instructions

Charging

Charge your PBH10 through any USB jack or wall charger. The

LED indicator will begin to blink red when charging. Before using

for the ﬁrst time, charge at least 4 hours. After the ﬁrst charge,

the headset will charge in 2 to 3 hours and the LED indicator will

stop blinking when the charge is complete.

Note: When the battery is fully charged, the LED indicator will

change to blue.

Power ON/OFF

Press and hold the ON/OFF button for 1 second to switch the

headset on. The LED will ﬂash blue when powered on. Press and

hold the ON/OFF button for 3 seconds to switch the headset

off. When powering off, the LED will ﬂash blue and then turn off

indicating the headset is off.

Pairing

While the headset is off, press and hold the ON/OFF – Bluetooth

Pairing buttons for 5 seconds to start pairing mode. Once the

headset is in the pairing mode (the LED will ﬂash red and blue),

select ‘LHB18’ among discovered Bluetooth devices on the

phone. If requested, enter the password ‘0000’ to pair the

headset. When connected, you will hear a beep and your mobile

device will show “Paired”.

Note: If the headset does not pair with another Bluetooth device

in 3 minutes, it will turn itself off.

6 7 8