User's Manual

Page 10 Page 11
ContentsTroubleshooting Compliance with FCC Regulations
The equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
Radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to Radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to Radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from which the
receiver is connected.
- Consult the dealer or an experienced Radio/television technician for
assistance.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE
HEADPHONES ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
The user is cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
If at any time in the future you should need to dispose
of this product, please note that waste electrical
products should not be disposed of with household
waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
Symptom
Music is not
streaming over
Bluetooth
PBH10 does not
answer phone calls
Music does not
resume after ending
a call
Not able to control
music from the
PBH10
No power
Solution
Make sure the PBH10 is
fully charged.
Check to make sure
both devices are paired
and connected over
Bluetooth.
Restart the PBH10 to
auto-connect with your
Bluetooth device.
Check to make sure
both devices are paired
and connected over
Bluetooth.
Restart the PBH10 to
auto-connect with your
Bluetooth device.
Press play to resume
music.
Check and make sure
your mobile device
supports Bluetooth
A2DP profile.
Caution!
Thfis devfice compflfies wfith part 15 of the FCC Rufles.
Operatfion fis subject to the foflflowfing two condfitfions:
(1) Thfis devfice may not cause harmfufl finterference, and
(2) thfis devfice must accept any finterference recefived,
fincfludfing finterference that may cause undesfired operatfion.
Cautfion: Any changes or modfi?catfions to thfis devfice not
expflficfitfly approved by manufacturer coufld vofid your t.
authorfity to operate thfis equfipmen