User's Manual

Page 4
COMPLIANCE REQUIREMENTS
The CMD-HHCP-xxx has been pre-certified by Linx for FCC Part-15 compliance
when used with an appropriate function module in keeping with the applications
allowed under section 15.231.
LABELING/INSTRUCTION REQUIREMENTS
The CMD-HHCP-xxx Remote Command Unit has already been labeled in
accordance with FCC regulations in effect as of the date of this document. No
further labeling of the unit is needed; however, it is necessary to include the
following statement in the end product’s instruction manual or insert card.
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class
B computing device, pursuant to FCC Rules. In order to maintain
compliance with FCC regulations, shielded cables must be used with
this equipment. Operation with non-approved equipment or unshielded
cables is likely to result in interference to radio and TV reception. The
user is cautioned that changes and modifications made to the
equipment without the approval of manufacturer could void the user's
authority to operate this equipment.
Place the above statement in the instruction manual or insert card.