User's Manual

Activating routes

Clearing routes

Switches

Select any route you’ve programmed by pressing

RTE and your chosen RTE ID#. Make sure you

press and hold the ID# button for one full second.

This ensures the command is issued to every switch

controller on your railroad.

“PRESS AND HOLD”. When you are

pressing the ID button, some of the

switches may not actually throw until

you’ve released the button. Switches

activate at different times once you’ve

selected the route—this keeps your

system (and your railroad’s power

supplies) from overloading due to

simultane ous activation of multiple

switches.

Clearing an existing route requires an abbreviated

version of programming new route. In this case, do

not add any switces to the route. This removes any

switches previously stored as part of this route.

Detail

Address Route #1

Press RTE

Press 1 for one full second

Route #1 has been selected. Switch #2 is

THROUGH, Switch #4 is OUT, and Switch

#14 is THROUGH

Clear Route #1

(erase all switch assignments)

Press RTE

Press 1

Press SET

Route #1 is now ready for new switch

assignments

You cannot remove an individual switch

from a RTE; you must clear the entire

route and start again

If you make an error during

re-programming, do not press SET; start

over—press RTE, the switch number, its

position, and then press SET

Example

