User's Manual

To save the complete recording,

1 Press <SET>

2 The screen reads TR1 sequence saved

In summary, if the led is blinking fast, you can record a trigger. If the led

is blinking slowly, you can record a sequence. If the led is not blinking,

you can press <record> briefly to clear and start recording

Note that only one recording can be saved for any trigger. Recording a

new sequence with the same trigger will erase the sequence previously

recorded with that trigger.

Playback

Because he trigger is a sequence of commands, the recording plays

whenever that sequence is entered.

Memory

There is a limit to the memory available for recording.

To see how much memory you have available,

1 Press <CTC>. Scroll to “Record Options”.

2 Then Press <MEM> to view Record Memory

(graph)

Now you can see how much memory remains. The grey-bar represents

Memory used.

While you are viewing, notice the boxes in the bottom of the screen

Insert diagram 59.7 of (Record Options “Memory”) here

The triggers are illustrated alpha-numerically in boxes above each soft-

key.

1 Scroll through all the triggers.

2 Soft key buttons are used to select each trigger to

view the recording.

When the trigger you are looking for appears,

1 press the soft-key under that Trigger.

Now you can view all the info about that recording.

1 -You will see the stored Trigger.

2 -You will see all the commands making up the

sequence, in order.

3 -You will see the duration in seconds.

4 -You will see the % of memory used by the selected

sequence.