User's Manual

26
Throw several switches
Press SW
Press ID# 9
Press THROUGH/OUT
Throw another switch (don’t press
SW again)
Press ID# 14
Press THROUGH/OUT
“Sticky” keys
Advanced operating techniques
The CAB-1L NEVER
FORGETS. Once you select
an ENG or TR, SW or ACC.
CAB-1 retains that ID# in
its memory, even when you
press other top-row address
keys like SW, RTE, or ACC.
THIS SYSTEM CAN HANDLE
IT. The LEGACY Control
System allows for the
continuous operation of up
to 100 locomotives. The only
limitations: available power
and operator capability.
Detail
Detail
Now slow Train #8; TR is the locomotive “stuck” in
CAB-1’s memory:
Press BRAKE
Activate Engine #1’s bell; press ENG (without “1”) to
make Engine #1 the active locomotive for CAB-1L’s
command buttons:
Press ENG
Press BELL
Activate Accessory #77:
Press ACC
Press 77
Press AUX1
“Jump” to Train #8 by pressing TR and any
command button:
Press TR
Press WSTL/HRN
WSTL/HRN sounded the horn and also enabled
numeric commands. Raise the RPM level for Train #8
by pressing 3 on the keypad
Press 3
Press SW to to redefine AUX1 as the THROUGH switch
command.
Press SW
Press THROUGH (throws switch #34)
“Jump” to Accessory #77 and deactivate it, again
using AUX1:
Press ACC
Press AUX1
Bring Engine #1 to a stop:
Press ENG
Throttle down to stall; bring Train #8 to a stop:
Press TR
Throttle down to stall
Example
