User's Manual

19
Maintaining and servicing your set
Replacing your Square Window Caboose’s lamp
T
o replace the lamp inside the caboose, first pull out the two end frames tabs from the slot formed
by the caboose body and roof. The end frame is hinged to the platform making it flexible. This
allows the end frame to bend downward away from the body. Next, lift off the roof from the window
shell and body. The window shell is held in place by four tabs on the sides of the shell (two on either
side) that lock into the windows on the caboose. To remove the window shell, carefully separate the
sides of the caboose while pulling up on the window shell until the tabs are released from the window.
Pull the window shell out. To remove the lamp, pull it straight up and replace it with bulb No. 620-
5100-300 available at your authorized Lionel Service Center or Lionel Service.
Insert the window shell back into the body making sure that the tabs snap into the windows. Insert
the roof into the window shell and fit the tabs on the end frames into the corresponding slots formed
by the roof and body.
Figure 13. Square window caboose lamp replacement
Window
tab
Window shell
End frame tab
End frame
tab
Hinge
Lamp no. 6205100300