User's Manual

12
Operating your train set
Running your train set
With track power unplugged, place your train set on the track.
Refer to the following section for information on coupling the cars.
3
4
Plug in your wall-pack power supply, connect
it to the track, and switch on the remote.
Move ‘em out!
Use your remote to run your train. You can adjust the speed
in forward or reverse, blow the whistle, sound the bell, or trigger an
announcement. Refer to page 14 for complete details.
1
5
Unplug the wall-pack power supply when you are done
running your trains.
2
Couple the locomotive to the tender that was included
with this set
Switch off your remote control to conserve the batteries.
Figure 5. Drawbar connection
Fit the tab on the locomotive drawbar into the slot on
the tender's drawbar as illustrated in Figure 5. Note that
the drawbar connection connects the locomotive and
tender electronically. Make the connection securely to
ensure good electrical contact.
Caution!
To prevent damage to the electronics, only couple the locomotive to the
tender that was included with this set. Do NOT mix and match LionChief
locomotives and tenders.