User's Manual

8
Adjusting the Locomotive Volume with the Universal Remote
T
his feature, is only available for LionChief Plus locomotives. To adjust the overall volume of the
locomotive’s sound system begin by placing the throttle in the top dead center position (so the
red LED is solidly illuminated and the locomotive is stopped). Press and hold the Announcement
button then turn the throttle to the left and / or right, this will increase and decrease the overall
locomotive volume. Continue holding the Announcement button when turning the throttle, you
can stay in this mode until the volume is at the level you desire. Once the volume level is set to the
level you want release the Announcement button and return the locomotive throttle to the top dead
center position again. (The new volume level will remain until you change it in the future, even
after power has been cycled.) If, after running the locomotive, you decide to change the volume,
simply follow the steps above to do so.
If the throttle is not in the top dead center position before or after the volume
adjustment process undesired operation will occur. Always start and finish the
volume adjustment process with the throttle in the top dead center position!
Note!
Remote Sleep Function
T
o conserve battery life the Universal Remote will enter a “sleep mode” when the power switch is
in the on position but there hasn’t been any activity (commands sent) to a locomotive after a
period of 10 minutes. When this “sleep mode” occurs the red LED at the top of the remote will dim.
To wake up from "sleep mode" simply cycle the power on the remote or press and hold any button
until the LED gets bright again.