71-2028-250 8/03 Inner Loop Add-on Track Pack Owner’s Manual
Congratulations! ongratulations on your purchase of the Lionel FasTrack Inner Passing Loop Add-on Track Pack! This track pack is the perfect addition to your train set loop, or four straight and eight curved sections that you can buy separately from an authorized Lionel dealer. C Inner Passing Loop Inventory O36 curve section Quarter curve RH manual switch LH manual switch 2 2 1 1 The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved.
Creating a Inner Passing Loop layout se the track section from the track pack and eight curve and four straight sections (available separately and included in ready-to-run train sets) to create an Inner Passing Loop layout. Refer to Figure 1 below as you assemble the track sections. U E B C A A A C B D O36 curve section Quarter curve Straight section RH manual switch LH manual switch Figure 1.
Joining the FasTrack track sections asTrack track sections join together easily. With interlocking roadbed sections and large rail tabs, the track fits together securely so you always get good electrical contact. Take a look at Figure 2 to see how to join the track sections. F 1. Line up your two sections of track. 2. Insert the rail tabs into the openings at the ends of the corresponding rails. 3. Press the sections together until the interlocking roadbed snaps into place. Rail tab Figure 2.
Throwing the switch s illustrated in Figure 3, rotate the top of the switch stand to throw the switch. These switches are equipped with a non-derailing feature. The train’s wheels automatically throw the blades to the proper position when the train travels toward the converging track. If you experience difficulties, simply throw the switch into the correct position for the train to travel using the switch stand control. A Switch target Switch handle Blades Figure 3.
Changing the switch stand location Y ou may choose to position the switch stands either inside or outside the loop of track. Follow these steps and refer to Figure 4 to change the location of the switch stands. 1. Remove the two screws that secure the small roadbed section to the switch and lift away the roadbed section. 2. Place the “blades,” or moving rails, in the proper position to make removing the switch stand roadbed section easier.
Connecting your transformer onnecting your transformer to your FasTrack layout is very simple. If you are adding on to your train set loop or you have a FasTrack terminal section with the wires already connected, you can connect your transformer directly to the FasTrack terminal section wires. Refer to the train set or power terminal section owner’s manual.
Limited Warranty/Lionel Service his Lionel product, including all mechanical and electrical components, moving parts, motors and structural components, except for light bulbs, is warranted to the original consumer-purchaser, for one year against original defects in materials or workmanship when purchased through an authorized Lionel merchant.