User's Manual

13
Maintenance and operations
Using 9.6 Volt rechargeable batteries (not included)
O
pen the battery compartment by sliding the locking tab forward on the top rear of the
tender.Then lift tender lid by curved angled rib and pulling backward. Refer to Figure 4
on page 7.
Place the 9.6 Volt rechargeable battery in the center slot of the large battery compartment
connecting battery power plug into it’s receptacle. See Figure 10.
Close the battery compartment by inserting the slot on the rear end of the tender lid onto
the retaining rib. Then lower the front end of the lid and secure by sliding the locking tab
backward.
The 9.6 Volt battery should be removed from the tender for charging as this produces heat
that could damage your tender.
It should be noted that the battery life of the rechargeable will be significantly less when
using 6 Alkaline ‘C’ batteries.
When using a 9.6V rechargeable battery DO NOT place any ‘C’ batteries
in the lower portion of the battery box. This could result in damage to the
engines electronics.
IMPORTANT!
Figure 10. Using a 9.6 Volt Rechargeable Batteries
9.6v batteries must be placed
vertically in the slot provided
as shown. Do not lay the
horizontally as this may cause
damage to your tender.
IMPORTANT!