B���� NE L��� OWNER'S MANUAL Rev: 08.29.
TABLE OF CONTENTS Product Information 2 2 3 3 3 3 3 4 4 5 5 Features Operation Calibration and Programming Preset Factory Code Programming New Code Maintenance Installation Bauer NE Installation Battery Installation Battery Plug Instructions Calibration and Programming Preset Factory Code Programming New Code Maintenance Troubleshooting 6 6 6 7 Bauer NE Fault Logic Limited Warranty Bauer NE Lock Assembly Product Information Features Thank-you for purchasing the Bauer NE.
Operation The Bauer NE is a 4 touch pad button programmable deadbolt lock (Fig. 1). The 4 buttons are labeled “1|2”, “3|4”, “5|6”, “7|8”. The button labeled “1|2” is the same button whether the number 1 or 2 is desired. Please note this handle uses Touch Technology. The buttons are activated by Touch and do not require pressing. Touch the button and lift finger from button for proper code entry. The following steps show how to operate the Bauer Lock: 1.
Installation Bauer NE Installation The following steps are graphically shown on the enclosed Bauer NE Installation schematic. 1. Remove old lock. 2. Clean cut-out. Remove any dirt, loose material, etc. 3. Install outside housing (the portion that includes the Touch Pad) with the dead bolt in the unlocked position (Fig. 2A). 4. Attach the (2) 8x32 screws (Fig. 2B) into the portion of the handle that has the Plunger and Dead Bolt. This is on the edge (Fig. 2C) of the door. 5.
Battery Installation The Bauer NE uses 4 AA batteries for operation. We do not recommend zinc carbon batteries for this application. Batteries not included. NOTE: Fresh batteries should be installed as necessary. Battery Life is highly dependent upon battery quality, usage, and environment (temperature). Remove batteries if the lock will not be used for extended periods of time. The following steps are shown on the enclosed Battery Installation diagram: 1. Remove (2) 4x40 screws (Fig.
Troubleshooting NOTE: If the problem is not found on this list please call 1-866-682-2837 for assistance. Problem After installation, the touch pad does not work. Dead bolt not engaging into door frame. Code is not working. Inside paddle is not opening the latch. Buttons light but the dead bolt does not activate. Possible Fixes Batteries are dead or are not installed properly. Plug is not engaged properly. Obstructions in the door frame. Remove batteries for 10 seconds then program a new code.
BAUER NE LOCK ASSEMBLY DOORS A Bauer Keyless Entry Components Callout A Rev: 08.29.
All information contained within may be distributed as a full document only, unless otherwise permitted by explicit consent of Lippert Components Inc. to distribute individual parts. All information contained within is subject to change without notice. New editions will be posted on www.lci1. com and can be downloaded for free. Information contained within is considered factual until made obsolete by a *NEW* revision. Please recycle all obsolete materials.