Owner's manual

ManualsBrandsLippert Components ManualsHardwareCA-CGL

1. Prepare the Guide Plates and Anchor Plates for installation by using the adhesive strips

provided to attach the black plastic spacers to the Guide Plate and Anchor Plate as shown in

Fig. 1 & 2.

2. Position the silver Guide Plate such

that holes marked "3" are toward bed

side wall, the top edge is 11

/2 inches

down from the top of the bed rail, and

the outside edge is 1/8" in from corner.

(Fig. 3 & 4) Set plate parallel to bed

floor and secure in place with masking

tape.

3. Drill

/16" pilot holes in bed front

wall through the two small holes in

guide plate. If a stabilizer bar (SB-100)

is being installed (recommended),

Remove Guide Plates and attach stabil-

izer bar per instructions enclosed with bar. If no stabilizer bar is used, insert and tighten the

small sheet metal screws to secure Guide Plates to bed, then remove tape. Otherwise, do this

after the bar is attached.

4. Once both Guide Plates are attached to the bed with the small sheet metal screws, use the

Guide Plates as drill guides and drill

/16” holes through the bed front wall through hole pairs

marked 1 & 3. (Fig. 4) Caution, do not allow drill bit to strike cab. Place a board

or some other barrier between bed and cab while drilling.

1999 - 2003 Chevy Silverado

1999 - 2003 GMC Sierra

HAPPIJAC COMPANY

Model:

CGL

505 N. Kays Drive, Kaysville, Utah 84037

INSTALLATION INSTRUCTIONS

FRONT ANCHOR INSTALLATIONSFRONT ANCHOR INSTALLATIONS

5. Slip the black Anchor Plates (with spacers attached)

between the bed & cab and start all four 1" X 3/8" bolts

through Guide Plate and bed, into threaded holes in Black

Anchor Plate. Important: Start all 4 before tightening.

( Hint: These will start much easier if you run the bolts

through the plate prior to installation to clear the paint

from the holes.)

6. Once all 4 bolts are started, remove the sheet metal

screws, then tighten all bolts just until all parts draw

snuggly together.

IMPORTANT NOTE: This plate will roughly follow the contour of the bed front. Since

this is a "universal" plate, designed to fit a range of trucks, it will not follow the contour

perfectly, however, all parts will draw together when tightened down.

See reverse side for rear anchor installation.

Fig. 1

Fig. 2

Align holes in

spacer with holes

marked "1" on

Guide Plate.

Fig. 3 Fig. 4

/2"

Sheet

metal

screws

Fig. 5

Anchor Plate

Summary of content (2 pages)

PAGE 1
HAPPIJAC Model: CA-CGL COMPANY 505 N. Kays Drive, Kaysville, Utah 84037 1999 - 2003 Chevy Silverado 1999 - 2003 GMC Sierra INSTALLATION INSTRUCTIONS FRONT ANCHOR INSTALLATIONS 1. Prepare the Guide Plates and Anchor Plates for installation by using the adhesive strips provided to attach the black plastic spacers to the Guide Plate and Anchor Plate as shown in Fig. 1 & 2. 2.
PAGE 2
REAR ANCHOR INSTALLATION NOTE: Rear anchors are installed in the end of the bumper. When properly installed, the bumper mount tiedowns provide excellent performance and a clean attractive appearance. There is no precise mounting location since a variety of bumpers may be installed. The general guidelines are as follows: Fig. 4 Flats Horizontal 1. Mounting location should be as flat & vertical as possible. Place well back from front edge of bumper but not on radius. 2.