C������ T����™ OEM INSTALL MANUAL Rev: 09.17.
TABLE OF CONTENTS Installation Correct Track™ Installation Kits - Equalizer Tandem Axle Triple Axle Correct Track™ Installation Kits - Equa-Flex Tandem Axle with Equa-Flex® Triple Axle With Equa-Flex® Rev: 09.17.
Installation Fig. 1 Hanger Cam Bolt 1. Cam/Bolt assembly should be installed into the hanger in the middle/neutral position. All cam assemblies should be installed in the same manner. Orient the cam so that the least amount of cam material showing is oriented to the bottom side of the hanger as shown above (Fig. 1). The loose cam plate should be installed on opposite side of hanger in the same orientation. 2. Finger tighten the flanged locknut onto the threaded end of bolt.
Correct Track™ Installation Kits - Equalizer NOTE: Figures 2-5 detail a Correct Track™ system installed on a standard steel equalizer suspension. Tandem Axle Fig. 2 - Tandem Axle Installed Fig. 3 - Tandem Axle Install Kit ES-1182 Rev: 09.17.
Triple Axle Fig. 4 - Triple Axle Installed Fig. 5 - Triple Axle Install Kit ES-1180 Rev: 09.17.
Correct Track™ Installation Kits - Equa-Flex NOTE: Figures 6-9 detail a Correct Track™ system installed on a suspension utilizing Equa-Flex®. Tandem Axle with Equa-Flex® Fig. 6 - Tandem Axle With Equa-Flex® Installed Fig. 7 - Tandem Axle With Equa-Flex® Kit ES-1185 Rev: 09.17.
Triple Axle With Equa-Flex® Fig. 8 - Triple Axle With Equa-Flex® Installed Fig. 9 - Triple Axle With Equa-Flex® ES-1186 Rev: 09.17.
All information contained within may be distributed as a full document only, unless otherwise permitted by explicit consent of Lippert Components Inc. to distribute individual parts. All information contained within is subject to change without notice. New editions will be posted on www.lci1. com and can be downloaded for free. Information contained within is considered factual until made obsolete by a *NEW* revision. Please recycle all obsolete materials.