User Manual

Rev: 09.17.2014
Page 3
Correct Track™ OEM Install Manual
1. Cam/Bolt assembly should be installed into the hanger in the middle/neutral position. All cam
assemblies should be installed in the same manner. Orient the cam so that the least amount of cam
material showing is oriented to the bottom side of the hanger as shown above (Fig. 1). The loose cam
plate should be installed on opposite side of hanger in the same orientation.
2. Finger tighten the flanged locknut onto the threaded end of bolt. Tighten nut until the flange bottoms
out on the shoulder of the bolt (approx 30-50 ft-lbs.)
3. Install is complete when bolt is centered on the hanger, both cam plates are oriented the same and
the nut is tight against bolt shoulder.
Fig. 1
Installation
Bolt
Cam
Hanger