Setup & Op User guide

18
INTRODUCTION - SECURITY
LOCKED
An owner/ofce security setting that limits the access of
drivers to a small number of delivery, system, and POS
elds.
To lock the LCR 600
1. Select the Security screen from the Conguration Menu.
2. Move the pointer  to User Key: eld and press the
EntEr button.
3. Enter an alphanumeric password in the eld edit box and
press the EntEr button
4. Move the pointer  to the Security: eld and press the
EntEr button.
5. Move the pointer  to Locked in the list box and press
the EntEr button.
UNLOCKED
An owner/ofce security setting that allows drivers
access to a large number delivery, system, and POS
elds.
To unlock the LCR 600
1. Select the Security screen from the Conguration Menu.
2. Move the pointer  to User Key: eld and press the
EntEr button.
3. Enter the same alphanumeric password that was
entered when the LCR 600 was locked. The value of the
Security: eld will change to UNLOCKED.
Throughout this manual, the security levels that
allow access to a each LCR 600 eld is included
with the eld denition. The abbreviation for
each security level is as follows:
L - Locked
U - Unlocked
C - Weights & Measures Calibration
P - Stop/Pause
F - Factory
Six O’clock Calibration Position
WEIGHTS & MEASURES CALIBRATION
The Weights & Measures Calibration security setting
allows access to all elds and functions necessary
for Weights & Measures approval and the complete
conguration of the LCR 600 for service.
To enter the Weights & Measures Calibration mode
1. Remove the faceplate around the red selector switch.
If the LCR 600 was Weights & Measures approved
beforehand, you will need to remove the lead seal and
wire threaded through the switchplate screws.
2. Turn the selector switch to the six o’clock position.
STOP/PAUSE
During deliveries, there are certain elds that may
be edited if the selector switch is turned to the STOP
(pause) position, for example, preset and miscellaneous
charges elds. After editing a eld, the delivery can be
continued by turning the selector switch back to RUN.
FACTORY
A security setting restricted to LC factory personnel.
Levels of Security
Many elds listed in the LCR 600 screens are accessible only while certain security levels are in place. The security
levels provide the safeguards essential for Weights & Measures approval, and they give owners and operators a
means of restricting drivers to certain functions. There are ve levels of security on the LCR 600: Locked, Unlocked,
Weights & Measures Calibration, Stop/Pause, and Factory.
When a delivery is active LCR 600 elds are not editable.
Active Delivery Status