Setup & Op User guide

SYSTEM SETUP

SYSTEM SETUP 1

Meter ID: (FE) C

The identication number of the meter the LCR 600 is

mounted on. If the LCR 600 is installed in a multiple-meter

system, it is important this number be unique. The number is

printed on the calibration/diagnostic ticket. LC recommends

entering the meter’s serial number to ensure identication.

LCP Node Address: (FE) C - U

Node address used by a host application, like the DMS i1000,

to communicate with the LCR 600.

Unit of Measure: (LB) C

The unit of ow measurement.

Gallons • Litres • Cubic M • Lbs (pounds) • Kgs • Barrels • Other

Decimal Digit: (LB) C

The decimal place of volume measurements shown on the display and printed tickets.

Hundredths • Tenths • Whole

Residual Processing: (LB) C

The treatment of excess decimal places when displaying and printing volume measurements

Round according to one half of the least signicant digit

Truncate disregards the excess digits

Flow Rate Base: (LB) C

The time unit of the measured ow rate.

Per Second • Per Minute • Per Hour

Flow Direction: (LB) C

The direction of ow through the meter. If the LCR 600 is counting in reverse (decreasing numbers), select the

opposite Flow Direction.

<− • −>

Printer: (LB) C

The type of printer connected to the LCR 600.

EPSON NewFontB EPSON 200 Roll and EPSON 220 Roll

EPSON NewFontA EPSON TM-T88iii

EPSON OldFontA EPSON 290 Slip and EPSON 295 Slip

EPSON OldFontB EPSON 300 Roll

OKIDATA ML184T OKIDATA ML184T

BLASTER Cognitive Solutions Thermal Printer.

L - Locked

U - Unlocked

C - Weights & Measures Calibration

P - Stop/Pause

F - Factory

Security Clearance

FE - Field Edit Box

LB - List Box

Field Type